Equivalent Specifications

BS EN 1982-2008 CC334G
CuAl11Fe6Ni6-C
DIN 1714 W Nr 2.0980.03

 		Tel +44 (0) 1782-816888  
Email sales@copperalloys.net
Print this page »

CC334G

A high strength nickel aluminium bronze meeting the requirements of BS EN 1982-2008 CC334G CuAl11Fe6Ni6-C. The alloy has greater wear properties than CC 333G and can be used for sleeve bearings with high peak loads. When used in bearing applications there needs to be adequate lubrication. The alloy is ideal for sea water applications. For engineers interested in higher integrity material, for more demanding applications, it is suggested that the wrought version of this alloy is considered - CW308G. Forgings in this material enable low cost volumetric inspection, and much greater control of mechanical properties than any castings.The alloy can also be specified to DIN 1714 W Nr 2.0980.03

Description Aluminium Bronze
Nominal Composition CuAl11Fe6Ni6-C
Alloy Type Cast

Typical Mechanical Properties

Tensile Strength (N/mm²) 750
Proof/Yield Strength (N/mm²) 380
Elongation (%) 5
Hardness Brinell 185
Impact Izod J20°C

Typical Physical Properties

Density g/cm³ 7.6
Melting Temperature Range °C 1060-1075
Thermal Conductivity W/mK 54
Electrical Resistivity μΩ.m15°C 22
Coefficient of Thermal Expansion 0-250°C 17

Copper Alloys Ltd has the ability to modify existing alloys for improved performance. Many customers have benefited from this in the past.

To discuss your requirements, call a member of Copper Alloys Ltd's technical team on +44 (0) 1782-816888, or email sales@copperalloys.net.

This Data is indicative only and must not be seen as a substitute for the full specification from which it is drawn. In particular, the mechanical property requirements vary widely with tempeter, product and product dimensions. The information is based on our present knowledge and is given in good faith. However, no liability will be acepted by the Company in respect of any action taken by any third party in reliance thereon.

As the products detailed may be used for a wide variety of purposes and as the Company has no control over their use; the Company specifically excludes all conditions or warranties expressed or implied by statute or otherwise as to dimensions, properties and/or fitness for any particular purpose.

Any advice given by the Company to any third party is given for that party's assistance only and without liability on the part of the Company. Any contract between the Company and a customer will be subject to the Company's Conditions of Sale. The extent of the Company's liabilities to any customer is clearly set out in those Conditions, a copy of which is available on request.