Equivalent Specifications
Key Features
Hard, strong, tough, resistant to wear, fine grained.
Good machinability and corrosion resistant to sea water. The addition of nickel increases the mechanical strength and corrosion resistance
Typical Uses
Worm wheels, gears, bushings for heavy loads and low speeds. Good resistance to pounding. Admiralty bronze suitable for marine pumps and valves. Plain bearing shells, moderately stressed slide and coupling components. Stern tubes.
Print this page »
BS1400 G3
A cast gunmetal containing nickel for increase physical properties. Comprising of 7% tin, 5.5% nickel and 2% zinc, the alloy conforms to BS1400 G3 CuSn7Ni5Zn3 and has no know European equivalent. This alloy can be heat treated to give increased strength and hardness, which imparts excellent wear and abrasion resistance. The alloy does need good lubrication and is suitable for slow moving parts.
Description |
Nickel Gunmetal |
Nominal Composition |
CuSn7Ni5Zn3 |
Alloy Type |
Cast |
Typical Mechanical Properties
Tensile Strength (N/mm²) |
350 |
Proof/Yield Strength (N/mm²) |
180 |
Elongation (%) |
20 |
Hardness Brinell |
100 |
Impact Izod J20°C |
|
Typical Physical Properties
Density g/cm³ |
8.8 |
Melting Temperature Range °C |
900-1020 |
Thermal Conductivity W/mK |
47 |
Electrical Resistivity μΩ.m15°C |
|
Coefficient of Thermal Expansion 0-250°C |
18 |
Relative Magnetic Permeability |
|
Coefficient of Friction |
|
This Data is indicative only and must not be seen as a substitute for the full specification from which it is drawn. In particular, the mechanical property requirements vary widely with tempeter, product and product dimensions. The information is based on our present knowledge and is given in good faith. However, no liability will be acepted by the Company in respect of any action taken by any third party in reliance thereon.
As the products detailed may be used for a wide variety of purposes and as the Company has no control over their use; the Company specifically excludes all conditions or warranties expressed or implied by statute or otherwise as to dimensions, properties and/or fitness for any particular purpose.
Any advice given by the Company to any third party is given for that party's assistance only and without liability on the part of the Company. Any contract between the Company and a customer will be subject to the Company's Conditions of Sale. The extent of the Company's liabilities to any customer is clearly set out in those Conditions, a copy of which is available on request.