DIN 17665 1983 2.0978
DIN 17678 1983 2.0978
DIN 17672 1983 2.0978
CuAl11Fe6Ni6
CuAl11NI6Fe5
BS EN 12165 CW 308G
CuAl11Ni
NFL 14-706
NFA 51-116
AMS 4590
C63020
NCT 10-641-01MD
CuAl11Ni5Fe5
One of the highest strength aluminium bronzes.
Aerospace: Bushings and bearings.
General engineering: Wear plates, dies.
Marine: Valves, hydraulic blocks, fixtures and fittings.
Tel +44 (0) 1782-816888
|
A French AFNOR aerospace specification for Nickel Aluminium Bronze CuAl11Ni5Fe5. This alloy is more greatly alloyed than NFL 14-705 and hence has higher mechanical properties and enhanced wear and anti galling characteristics. The alloy also meets the requirements of NFA 51-116, DIN 17665/17672 WN 2.0978 and EN 12163/12420 CW308G.
Description | Nickel Aluminium Bronze |
---|---|
Nominal Composition | CuAl11Ni5Fe5 |
Alloy Type | Wrought |
Tensile Strength (N/mm²) | 800 |
---|---|
Proof/Yield Strength (N/mm²) | 570 |
Elongation (%) | 4 |
Hardness Brinell | 215 |
Impact Izod J20°C |
Density g/cm³ | 7.6 |
---|---|
Melting Temperature Range °C | 1060-1075 |
Thermal Conductivity W/mK | 54 |
Electrical Resistivity μΩ.m15°C | 22 |
Coefficient of Thermal Expansion 0-250°C | 17 |
Relative Magnetic Permeability | |
Coefficient of Friction |
This Data is indicative only and must not be seen as a substitute for the full specification from which it is drawn. In particular, the mechanical property requirements vary widely with tempeter, product and product dimensions. The information is based on our present knowledge and is given in good faith. However, no liability will be acepted by the Company in respect of any action taken by any third party in reliance thereon.
As the products detailed may be used for a wide variety of purposes and as the Company has no control over their use; the Company specifically excludes all conditions or warranties expressed or implied by statute or otherwise as to dimensions, properties and/or fitness for any particular purpose.
Any advice given by the Company to any third party is given for that party's assistance only and without liability on the part of the Company. Any contract between the Company and a customer will be subject to the Company's Conditions of Sale. The extent of the Company's liabilities to any customer is clearly set out in those Conditions, a copy of which is available on request.